Shop fox SHOP FOX W1737, Руководство пользователя

Страница: 32 / 68

-30-
W1737/W1738 Owner's Manual (Mfg. 10/09+)
SE
RV
IC
E
NOTICE
The table has been adjusted at the factory and
should require no further attention. However, we
recommend verifying its parallelism with the sanding
roller.
Table Parallelism
The corners of the table can be independently adjusted
up or down. By disconnecting the chain and turning the
pertinent table elevation screw sprocket (
Figure 44
),
table parallelism can be achieved.
Adjusting the table parallelism can be a very tedious task
that takes a great amount of patience. DO NOT adjust the
table unless you are having trouble sanding your work-
piece to a uniform thickness.
If a table adjustment is needed, take precise notes on the
positioning of the table elevation screws. This will allow
the original setting to be re-established.
To adjust the table parallelism, do these steps:
1.
Pass a 37" wide board through the sander until the
entire surface of the board is making contact with
the sanding belt.
2.
Measure the thickness of the board at various points
around the edge.
3. If there is a variation of thickness, the table can be
adjusted accordingly.
4.
Disconnect the sander from the power source!
—For minor adjustment, loosen the table mounting
bolts shown in Figure 45 and rotate the elevation
screw flange.
—For major adjustment, mark the chain location on all
sprockets, remove the chain from only the sprocket
to be adjusted, and turn the sprocket counterclock-
wise to raise the table. One quarter of a turn raises
or lowers an elevation screw approximately 0.020".
5.
Reinstall the chain, tighten the bolts, and test the
machine.
Figure 44.
View of elevation screw
sprockets.
Elevation Screw
Sprockets
NOTICE
When adjusting the left front eleva-
tion screw, make the same adjustment
to the left rear elevation screw. This
ensures the height from the front to the
back of the table remains unchanged.
Do the same when adjusting the right
elevation screws.
Figure 45. Table mounting bolts and ele-
vation screw flange.
Table Mounting
Bolt
Elevation
Screw Flange