Shop fox SHOP FOX W1688, Инструкция по эксплуатации

Страница: 23 / 48

ADJUSTMENTS
-21-
Figure 34.
Straight edge across the rollers and
touching the platen graphite pad.
Figure 33.
Platen and retaining bolts.
Platen-to-Roller
Alignment
The platen-to-roller alignment for your Model
W1688 Edge Sander has been setup at the facto-
ry; however, due to shipping or long use of the
sander, the platen-to-roller alignment can
change. You can compensate for this normal
condition by adjusting the platen toward a
straight edge set across the rollers.
To adjust the platen-to-roller alignment, do
these steps:
1. Unplug the edge sander.
2.
Remove the sanding belt as outlined on
Page 16
.
3.
With the sander unplugged, loosen the two
3 ⁄
8
"-16 X 1" hex bolts. See
Figure 33
.
4.
Set a straightedge across the rollers and slide
the platen toward the straightedge so the
platen graphite pad is against the straight-
edge at both ends. See
Figure 34
.
5.
Slide the platen outward until there is a gap
of
1
⁄
16
"
between the rollers and the straight-
edge. See
Figure 34
.
6.
Tighten the two 3 ⁄
8
"-16 X 1" hex bolts.
7.
Install the sanding belt as outlined on
Page 16
.
Keep your machine
unplugged during all
assembly, adjustments,
or maintenance proce-
dures. Otherwise serious
personal injury may
occur!
NOTICE
DO NOT adjust the platen so the platen
graphite pad is more than
1 ⁄
16
"
past the
rollers. Otherwise, the belt and graphite pad
can make excessive heat and wear prema-
turely.
Gap Between Rollers
and Straight Edge
is 1 ⁄
16
"
Platen Graphite
Pad
Platen Mount
Hex Bolts