-15-
M1039 12-Speed Drill Press
SE
T
U
P
4.
Place the rack inside of the table bracket, mesh
it together with the pinion, and slide the table
support/rack assembly over the column, as shown in
Figure.11
.
5.
Slide the column ring over the column with the
beveled edge facing down (
Figure.12
), fit the
beveled edge of the column ring over the rack, and
tighten the setscrew.
Note:
Make sure the rack is seated firmly in the
lower ring before tightening the setscrew. Do not
over-tighten the setscrew or you may split the
column ring.
6.
Install the crank handle over the pinion shaft, and
tighten the setscrew in the crank handle against the
flat part of the pinion shaft.
7.
Thread the handle into the crank handle.
8.
Thread the large lock lever into the back of the
table bracket approximately three turns, for now.
9.
Thread the small lock lever into the front part of the
table bracket approximately three turns, for now.
The assembly should now be assembled as shown in
Figure.13
.
Figure.11.
Sliding table bracket and rack
over column.
Figure.12.
Correct column ring
orientation.
Figure.13.
Handles and lock levers
installed.
Large Lock
Lever
Crank Handle
Small Lock
Lever