Shop fox SHOP FOX M1036, Руководство пользователя

Страница: 30 / 41

-27-
M1036 Micro Mill
M
A
INTE
N
A
N
CE
Regular lubrication will ensure your mill performs at its
highest potential.
Place two to three drops of ISO 68 or SAE 20W non-
detergent oil or similar lubricant directly on the following
areas each time you use your mill (see
Figure.27
):
• Cross slide and saddle ways
• Quill shaft
Apply a light weight lithium based grease directly to these
points once a month or more frequently as needed:
• Longitudinal leadscrew (
Figure.28
)
• Crossfeed leadscrew ( Figure.29 )
Note: Pry up the leadscrew cover to access the crossfeed
leadscrew.
Lubrication
Figure.27.
Points of lubrication.
Figure.28.
Longitudinal leadscrew.
Lack. of. lubrication. causes. poor. machine. perfor-
mance..Keep.your.mill.lubricated.to.reduce.wear.on.
parts.and.discourage.oxidation.
NOTICE
Figure.29. Crossfeed leadscrew.
Since all bearings are sealed and permanently lubricated,
simply leave them alone until they need to be replaced.
Do not lubricate them.
This machine does need lubrication in other places.
Lubricate.the.following.areas.every.six.to.twelve.
months.according.to.frequency.of.use:
•. Blade.angling.trunnions. These should be lubricated
with 6 or 7 drops of light machine oil.
•. Blade.height.trunnion.
This should also be
lubricated with 6 or 7 drops of light machine oil.
•. The.two.worm.gears. should be lubricated with
either graphite or white lithium grease.