BACK PANEL - SWITCH CONTROLS
BACK PANEL
11
1. DC POWER INLET:
The Switcher is fi tted with a DC power plug input connector.
Ensure that the used is of an approved type and is of suffi cient
current carrying connector capacity with the correct voltage and
connector polarity. 12Volt DC power supply 5A Max (Center pin
positive).
2. IR EXTENDER CONTROL:
Support one of IR Extender. Extend distance maximum 300
Meters / ~984 feet. When you plug the External IR extender into
the switcher, the front panel IR receiver remain active.
3. RS-232 CONNECTION:
RS-232 control port to allow for interfacing to a PC. Such as a
computer or touch panel control, to the switcher via this DB-9pin
Female connector for serial RS-232 control.
4. ETHERNET CONNECTION:
ETHERNET control port to allow for TCP/IP interfacing to a PC.
Such as a computer or touch panel control (not a web-browser), to
the switcher via this RJ-45 Female connector to control switcher.
Power Socket :
DC Jack - inner OD Ø 2.1mm (+ )
Outside OD Ø 5.5mm (GND)
Power input - 12VDC, 5A
IR Extender Jack:
Female Jack - inner OD Ø 3.5mm
Remote Port:
DB-9pin Female connector
Remote Port :
Control the switcher RJ-45 Female
connector
Ethernet Port:
Note: the Ethernet port and RS-232 port cannot
be used simultaneously. Any connection to the
Ethernet port will disable serial commands send
to the RS-232 port.
