5
FRONT PANEL
FRONT PANEL
1
POWER SWITCH
The power switch turns the unit on and off. The LED will illuminate red to indicate that the switcher is ON and is receiving power.
2
OUTPUT SOURCES STATUS LED DISPLAY
Output channel 1 to 8 show from LED display illuminates red to indicate that a video source is present on that input.
3
INPUT SOURCES SELECT BUTTONS
A separate output-1 To 8 source select buttons are provided for each destination. Select sources are 1-8 Component Video-Audio.
4
SOURCES SETUP BUTTONS
Setup the input sources 1 ~ 8 channel
5
IR SENSOR
The IR sensor receives IR commands from the supplied remote controller.
6
19 INCH EAR MOUNT PAIR
19 inch 2U(2D) high case Ear Mount pair Part number : 2U-440L
EXP. : HOW TO SWITCH CH-08 WHEN WORKING ON CH-01
Please press < Select > push button till CH-08, then press < SET > push button to con
fi
rm.
PS : If without press < SET > push button to con
fi
rm within 1 second, LED display will
fl
ash
fi
ve times for time interval and return back to CH-01.
OPERATING THE UNIT
Once you have connected the SB-5588 as described above, you must be certain that the input are being fed appropriate signals and are
not suffering from signal loss due to cabling problems or problems with the source device.
If the input signals to the SB-5588 are appropriate, switch the power switch to <ON> and you should see and hear the signals on the
devices you have connected to the various output connectors of the SB-5588.
POWER AND CONNECTIONS
This unit is not disconnected from the AC power source as long as it is connected to the wall outlet. The off state for this unit is called
standby mode. In standby mode the unit is designed to consume a reduced quantity of power compared to normal operating modes.
When not using the unit for a long period of time. Insure that the AC power cord is disconnected from the wall outlet.
The AC wall outlet should be installed near to the unit and be easily accessible.
Do not plug in or attempt to operate an obviously damaged unit.