XY400–2 Maintenance Manual
Overview
4
The wire harness shall be clamped at the position without
contacting a rotating part or a removing element.
The wire harness shall be clamped at the position without
contacting a part that generates high temperature.
The wire harness shall be clamped at the position without
contacting the edge or sharp corners of the vehicle body.
The wire harness shall be incapable of passing through the
position contacting a bolt, a screw head or any front part.
The wire harness shall not be slackened or be forcibly pulled.
If the wire harness has to contact the edge or sharp corner
parts, the contacting part shall be protected with hose or
adhesive tape.
In case of a wire harness with garland, it shall be reliably
harnessed.
Do not damage the garnish of the wire harness.
Once the wire harness is damaged, repair it by coiling with
plastic adhesive tape.
While mounting parts and components, do not press the wire
harness.
Do not mount wire harness with it twisted.
14. When wiring, note when turning it leftwards or rightwards
to the limit position, the wire harness shall not be
tightened up or slackened, and make sure there is no
significant bending, pressing, intervening of marginal
parts.
15. While using the test table, operate according to the
maintenance manual after understanding the explanations
in the instruction manual.
Do not touch!
Pay attention not to press it.
Do not
pull!
