M23006
M23005
M23004
Installing a Tool Attachment
1. Place the M230 Multipurpose Tool
Carrier and the Tool Assembly on a
clean, flat surface so that both
assemblies fit end to end. The
M230 assembly should be facing
up, and the tool assembly should be
positioned with the locking hole in
the tube end facing up.
See Figure 4.
Tool
Assembly
M230 Tube
Assembly
Coupler
Latch
Coupler
Screw
Knob
Locking
Hole
Latch Protector
(extended)
Latch Protector
(lowered)
Coupler Screw
Knob
Coupler
Press
Latch
Figure 4
Figure 5
Figure 6
ASSEMBLY
9
Assembly
Removing a Tool Attachment
1. With the unit on a clean, flat
surface, loosen the coupler screw.
The spring-loaded coupler protec-
tor should pop up.
2. Press down on the latch with your
finger or thumb. This releases the
coupler lock. See Figure 6.
3. Pull the tool assembly out of the
coupler.
2. Slip off the protective covers from
the ends of both tubes, and loosen
the coupler screw knob.
3. Insert the upper tube assembly into
the coupler, with the tool decal
facing up, until the line of the decal
is flush with the end of the coupler.
Twist the tool back and forth until
you are sure it snaps in place by the
coupler latch. See Figure 4.
4. When the two tube halves are
locked together, press down on the
spring-loaded latch protector and
tighten the coupler screw.
See Figure 5.
CAUTION!
Keep the open ends of the tubes
clean and free of impurities!
MAINTENANCE
18
135-hour Maintenance
After every 135 hours of operation
or if engine becomes hard to start
and has low power. The spark
arrester screen should be inspected
and cleaned.
Engine Cover
Engine Cover
Knob
Figure 18
Spark
Arrestor
Screen
1. Remove the spark plug boot.
2. Remove the engine cover by
loosening the engine cover knob
(the knob is captive) and lifting the
cover from the engine.
WARNING!
Never operate the unit with a
damaged or missing muffler or
spark arrester! Operating with
missing or damaged exhaust
components is a fire hazard and
could also damage your hearing.
3. Remove the spark arrester
screen screw.
4. Remove the spark arrester screen
and clean with a stiff bristle brush.
IMPORTANT!
If carbon deposits are severe or if no
performance improvement is noted,
your Multipurpose Tool Carrier
should be returned to your Shindaiwa
authorized servicing dealer.
5. Reassemble the spark arrester
screen and engine cover in
reverse order.
Spark Arrestor
Retaining Screw
Muffler
