11
Stopping the Engine
1. Cool the engine by allowing it to idle for 2–3 minutes.
2. Move the ignition switch to the “
O
” or STOP position. See Figure 8.
Starting a Flooded Engine
Figure 8
Ignition
Switch
Ignition OFF
Starting A Flooded Engine
1. Slide the ignition switch to the “
I
” (ON) position.
2. Open the choke, put the throttle lever in the full throttle position, then clear excess fuel from the combustion chamber by
cranking the engine several times.
3.
If the engine still fails to start or fire, refer to the troubleshooting flow chart at the end of this manual.
Operation
■
Squeezing the throttle increases engine speed, causing the clutch to engage and operate the cutters.
■
Releasing the throttle decreases engine speed, causing the cutters to slow, and then stop altogether as the clutch
disengages.
■
Use a sweeping motion when cutting, and vary throttle settings often.
■
Avoid cutting material larger than 1.3 cm (1/2 inch) in diameter.
WARNING!
If engine does not stop when stop switch is moved to STOP
position,close choke - COLD START position - to stall engine. Have your
Shindaiwa dealer repair stop switch before using hedge trimmer again.
WARNING!
Operation of this equipment may create sparks that can start fires. This unit is equipped with a spark arrestor
to prevent discharge of hot particles from the engine. Metal blade use also can create sparks if the blade strikes rocks,
metal, or other hard objects. Contact local fire authorities for laws or regulations regarding fire prevention requirements.