14
Before you start
Before you start
Assembly
Install blower pipes
Place the blower upright on the ground or on a sturdy work sur-
face.
1.
Grasp the blower pipe and push the pipe over the blower dis-
charge port and locking pins.
2.
Lock the blower pipe to the blower discharge port by rotating
the pipe until the locking pin snaps into place.
3.
Grasp the nozzle with the mark "THIS SIDE UP" (A) posi-
tioned and then push the nozzle over the blower pipe and
locking pins.
4.
Lock the nozzle to the blower pipe by rotating the nozzle.
(Mark "THIS SIDE UP" must face up)
Remove blower pipes
1.
To detach the blower pipe, push the locking pin in and rotate
pipe anticlockwise. The hex wrench can be used.
WARNING
Read the operator's manual carefully to ensure that you assemble the product correctly.
Never perform maintenance or assembly procedures with engine running.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
1. Blower pipe
2. Locking pin
1. Nozzle
2. Blower pipe
3. Locking pin
IMPORTANT
Blower pipe installation affects both blower balance and per-
formance. The pipe and nozzle are correctly installed when the
mark "THIS SIDE UP" is visible to the operator during normal
operation.
1. Blower pipe
