Shindaiwa DG150MM, Руководство владельца и эксплуатации

Страница: 17 / 48

14
Throttle Lever
Fixing Nut
Frequency
Adjusting Screw
(3) Circuit Breaker
By turning this circuit breaker on the control panel to
“ON”, Power will be
transferred to the output receptacles and to the load side.
The breaker trips to
“OFF”, either overload or short-circuit.
(4) Earth Leakage Relay
When current leak occurs, it trips to stop power transmission to load.
< Note >

Do not use this relay as the
“ON/OFF” switch to the load.
Voltage Regulator and Throttle Lever
(1) Voltage Regulator
The dial adjusts generator output voltage.
By turning the dial clockwise, an operator can increases the voltage.
By turning the dial counter-clockwise, an operator can decrease the
voltage.
(2) Throttle Lever
The throttle lever is to adjust the engine speed.
Set the lever to
“IDLING” position when the
engine starts and warms up or cools down.
When the rated power is used, set the lever to
RUN (50 or 60Hz).
(3) Frequency Adjusting Screw
Set the throttle lever to RUN and loosen the
fixing nut.
Frequency increases when turning the screw
positions
“HIGH”. Position the screw to “LOW”
to decrease the frequency.
< Note >

The equipment is set at 50Hz at delivery from the factory. For the 60Hz areas,
change to 60Hz according to the above procedure.

Make sure that the frequency set by selector switch and equipment should be
identical.
(4) Ammeter Selector Switch
The ammeter selector switch is for selecting the output current displ
ayed in ammeter. Change the switch to display the following output
terminal current on theammeter.
・
Switch Selection
○“
R
”
:3-phase R phase
○“
S
”
:3-phase S phase
○“
T
”
:3-phase T phase