Shindaiwa 62640-94313, Руководство владельца/оператора

Страница: 9 / 20

9
WARNING!
When the engine starts or is running–
even at idle–the hedge trimmer cutter
blade may move (oscillate). Keep
your hands and your body away from
the cutter assembly while starting the
engine!
Starting A Flooded Engine
1. Disconnect the spark plug lead and use
the spark plug wrench to remove the
spark plug (turn counter clockwise to
remove).
2. Slide the ignition switch to the “O”
(STOP) position.
n
If the spark plug is fouled or soaked
with fuel, clean the plug as necessary.
3. Open the choke (Figure 22) and fully
depress the throttle lever with your left
hand, then pull the starter handle rap-
idly with your right hand to clear excess
fuel from the combustion chamber.
Starting the Engine
5. While holding the outer tube firmly
with left hand. Use your other hand
to slowly pull the recoil starter handle
until resistance is felt, then pull quickly
to start the engine.
3. Press the primer bulb until fuel can be seen
flowing in the transparent return tube.
Make sure
the cutting
attachment
is clear of
obstructions!
IMPORTANT!
Engine ignition is controlled by a two
position switch mounted on the throttle
housing labeled, "I" for ON or START and
"O" for OFF or STOP.
Figure 18
Figure 19
Figure 21
IMPORTANT!
The primer system only pushes fuel
through the carburetor. Repeatedly
pressing the primer bulb will not flood the
engine with fuel.
CAUTION!
Do not pull the recoil starter to the end
of the rope travel. Pulling the recoil
starter to the end of the rope travel can
damage the starter.
ON
1. Slide the ignition switch to the “ON”
position. See Figure 18.
2. Set the throttle lever to the “fast idle”;
a. Squeeze the throttle lever toward the
handgrip on the shaft tube.
b. Depress and hold the throttle lock
button.
c.
While depressing the throttle lock
button, release the throttle lever.
See Figure 18.
Throttle Lock
Button
4. Set the choke
lever to the
CLOSED posi-
tion if engine
is cold.
Figure 20
Never start the engine from the
operating position.
When the Engine Starts...
n
After the engine starts, allow the engine
to warm up at idle 2 or 3 minutes before
operating the unit.
n
Advancing the throttle makes the cut-
ting attachment
oscillate
faster; releas-
ing the throttle permits the attachment
to stop
oscillat
ing. If the cutting attach-
ment continues to
oscillate
when the
engine returns to idle, carburetor idle
speed should be adjusted (see "Adjust-
ing Engine Idle" on the next page).
IMPORTANT!
If the engine fails to start after several
attempts with the choke in the closed
position, the engine may be flooded
with fuel. If flooding is suspected,
move the choke lever to the open position
and repeatedly pull the recoil starter to
remove excess fuel and start the engine.
If the engine still fails to start, refer to the
troubleshooting section of this manual.
5. When the engine starts, slowly move
the choke lever to the "OPEN" position.
See Figure 22. (If the engine stops after
the initial start, close the choke and
restart.)
Figure 22
WARNING!
Primer Bulb
Return Tube
Open
Figure 20
Closed
Figure 22