Shindaiwa 358Ts, Руководство оператора, Страница: 16 / 34

16 358Ts
WHEN THE ENGINE IS COLD
CAUTION
Make sure the bar and chain are free from
any obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock
chain brake before starting.
• Fill the fuel tank with fuel mixture.
It is not permitted to fill fuel above the shoulder
level of fuel tank.
• Fill the chain oil tank with lubricant.
Do not over fill.
• Move the control (choke / ignition switch) lever
forward to “Cold Start” position.
• Push purge pump 3 to 4 times or until fuel is
visible in purge pump.
• Securely hold the chain saw as shown.
When starting the chain saw place the unit on
flat ground and hold the front handle with left
hand and hold firmly the rear end of rear handle
with right knee and pull starter handle with right
hand several times until first firing sound.
• Return the control lever to
“Warm Start”
position as soon as engine starts to fire, when
first firing sound is heard.
• Pull starter handle to start the engine.
• When engine starts, immediately squeeze and
release throttle trigger for disengaging throttle
latch and returning engine to idle, and pull front
hand guard towards the operator immediately.
(Chain brake unlocked position)
WHEN THE ENGINE IS WARM
CAUTION
Make sure the bar and chain are free from
any obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock
chain brake before starting.
• Confirm there is fuel and chain oil in the tanks.
• Move the control lever to
“Warm Start”
position.
• Securely hold the chain saw as shown and pull
starter handle.
• Choke may be used if necessary, but after first
firing sound, pull throttle trigger to release choke.
• After starting the engine, pull front hand guard
towards the operator immediately.
(Chain brake unlocked position)
Chain brake
Unlock chain brake
Warm Start
Control lever
Chain brake
Starter handle
Unlock chain brake
Purge pump
Cold Start
Warm Start
Control lever