SI-74Y0A
CJ-8S40
Cassette Joint
General Safety Information
WARNING
– To avoid serious injuries:
NOTE:
The CJ-8S40 cassette joint should only be
used with sprockets from 16T to 23T.
When lubricating the chain or the sprockets, be
careful not to get any oil on the rubber bellows
or the rubber cover of the cassette joint.
For maximum performance we highly
recommend Shimano lubricants and
maintenance products.
Parts are not guaranteed against natural wear
or deterioration resulting from normal use.
Obtain and read the service instructions
carefully prior to installing the parts. Loose,
worn, or damaged parts may cause serious
injury to the rider.
We strongly recommend only using genuine
Shimano replacement parts.
Read these Technical Service Instructions
carefully, and keep them in a safe place for
later reference.
Technical Service Instructions
Left
Fork end
Non-turn washer
Reversed
Standard
5R/ Yellow
6R/Silver
5L / Brown
6L / White
Mark / Color
Size
Right
7R/ Black
7L /Gray
Reversed
(full chain case)
5R/ Yellow
= 0
= 0
5L / Brown
7R
The projecting parts should be on the fork end
side.
Install the non-turn washers so that the
projecting parts is securely in the fork end
grooves on either side of the hub axle.
Mark
Different types of left and right non-turn washers are
available for use with standard and reversed fork
ends. Use whichever non-turn washers are suitable.
Installation of the cassette joint
Refer to the Service Instructions for the Inter-8 hub for
details on installation of the cassette joint to the hub and
installation of the non-turn washer.
Note:
20
38
t
