Shihlin SA3 Series, Руководство пользователя

Страница: 223 / 423

Communication parameter group 07
PARAMETER DESCRIPTION 221
Communication EEPROM write selection

When parameter write in is performed by RS485, parameters can store in RAM or RAM only.

If change parameter value frequently, set "1" in 07-11(P.34). When 07-11(P.34) set to "0" EEPROM lifetime will be
shorter due to constantly write in.
Note: Set 07-11 (P.34) =1 (RAM only), when the power of inverter is turned off, parameters changed will not be
memorized. When power on again, all parameters will still be the setting previously saved in EEPROM.
5.8.3 Canopen protocol

Setting for using Canopen communication card (optional)
Parameter Name Default Setting Range Content
07-15
P.800 CANopen slave
address
0 0～127 ---
07-16
P.801
CANopen bit rate 0
0 1Mbps
1 500Kbps
2 250K/280Kbps
3 125Kbps
4 100Kbps
5 50Kbps
07-17
P.802 CANopen
communication status
0
0 Node retry status
1 Communication retry status
2 Retry completion status
3
Pre-operation status
4 Operating status
5 Stop status
07-18
P.803 CANopen control
status
0
0 Boot not completed status
1
Forbidden operation state
2
Pre-excitation status
3
Excitation state
5 Allowed operating status
7
Quick action stop status
13
Trigger error action status
14
Error status
Canopen protocol

Parameters 07-17(P.802) and 07-18(P.803) are Read only parameters, which are used to monitor the status of
Canopen communication card (optional) in use.
5.8.4 Communication card version

Show expansion card program version.
Parameter Name Default Setting Range Content
07-44
P.829
Version of EP301
communication card
Read
only
Read only
---
Setting
Setting