Controls
The device makes use of dual-function controls: each knob and switch can have different functions depending on the
situation. Primary functions with direct access are printed in bold font on the pedal. Secondary functions which can
be accessed by holding down the
TAP / ALT
footswitch are printed in a box on the pedal and are
underlined
in this
document.
●
The
PROGRAM
knob selects a program/algorithm from a bank.
●
The
X-MIX
knob controls the cross mix between the dry and wet signals.
●
The
PDL/TIME
knob controls pre-delay (for the RV bank) or the time interval (for the FX bank). This knob works
in conjunction with the
BEAT
switch.
Read more in the
section.
●
The
DECAY
knob controls the decay for reverb/delay. Press and hold the
ON/HOLD
footswitch to go to the fully
CW position on this knob.
●
The
CHARACTER
knob controls an algorithm-dependent parameter.
Read more in the
section.
●
The
BANK
switch selects the program bank:
○
UP:
UD
(User Defined) — user-selected algorithms.
○
CENTER:
FX
(Effects) — various spatial effects.
○
DOWN:
RV
(Reverberation) — reverb effects.
Read more in the
section.
●
The
BEAT
switch selects the beat division for the tempo set by the
PDL/TIME
knob or the
TAP
footswitch:
○
UP:
1/1
(quarter note).
○
CENTER:
3/4
(dotted 8th).
○
DOWN:
2/3
(quarter note triplets).
The beat divisions can be changed via the config file.
●
The
ON / HOLD
footswitch has several functions:
○
Press once to turn the effect on or off.
○
Press and hold to enter Hold Mode (gradual ramp-up towards infinite decay).
○
Press twice to switch between the Quick Access program (program 1 in UD bank) and the current program.
○
Press and hold while changing the
BEAT
switch position to select bypass type. Set the
BEAT
switch to the
UP position for no reverb tails in bypass. Set the
BEAT
switch to the DOWN position for reverb tails in
bypass.
Read more in the
section.
●
The
TAP / ALT
footswitch has several functions:
○
Press briefly several times to set the tempo (
TAP
). The tempo is set after two consecutive taps. When using
Force programs, press this footswitch to “freeze” the incoming signal.
○
Press and hold to access secondary functions of other controls (printed in a box on the pedal and
underlined
in this document).
When you press and hold the
TAP / ALT
footswitch, the LED above it starts glowing blue. This indicates that secondary
functions of the controls are being accessed.
Tweaking secondary control values (while holding down the
TAP / ALT
footswitch) doesn’t affect primary control
values, and vice versa. The primary and secondary functions are completely independent, but only the last tweaked
value of each control is physically visible.
