Sheyenne tooling & Mfg 500CT, Руководство оператора

Страница: 36 / 62

OPERATION (cont)
WARNING: To avoid serious
personal injury: Do not use hands or feet to
unclog chute or any other part of the
machine. Do not attempt to clear clogged
chute of snow chute while tractor engine is
running. If the chute clogs, disengage the
drive shaft, shut off the tractor engine,
remove the ignition key, wait for all
movement to stop, and then clear the snow
from the chute. Use a long piece of wood
( approx. 3 feet) to unclog the blower.
WARNING: To avoid serious
injuries: Keep clear of rotating parts. Do not
put hands or feet under, or into any part of
the snowblower with engine running.
SKID SHOE ADJUSTMENT
Adjust the skid shoes so the the snowblower runs
level and /or parallel to the grounds surface.
Both skid shoes should be adjusted to the same
height. Adequate clearance should be provided
to prevent cutting edge from picking-up stones.
Adjustment is done by moving washers and
spacers above or below the mounting tube.
IMPORTANT: The fan and auger are
driven by a hydraulic motor. Both the tractor
relief valve and two shear bolts protect the
snowblower. More specifically, model 600
blowers built after September 2011 and model
500 blowers built after October 2012 have shear
bolts on the top cross shaft for the fan or
impeller drive sprockets and the auger drive.
When an object blocks the fan or the auger, the
relief valve bypasses or the shear bolt(s) break
and the snowblower stops. Once the object is
removed and shear bolts are replaced, the
snowblower can be restarted.
CAUTION: Continuous running of the
snowblower at or over relief valve setting is
inefficient, and will cause hydraulic system
temperature to rise.
In deep snow it is good practice to cut the top
layer first, back-up, then go forward to take
another layer.
To transport or travel on roads, disengage the
hydraulic system and raise the snowblower to a
reasonable height.
MECHANICAL SPECIFCATIONS
Feature 5 Foot
Specifications
6 Foot
Specifications
Working
Width 60” 74”
Working
Height 28” 28”
Single/Dual
Auger Single Single
Auger
Diameter 18” 18”
Flighting
Thickness 1/4” 1/4”
Fan Diameter 18” 18”
Cutting Edge,
Replaceable 1/2” x 4” x
56.6” Long
1/2” x 4” x 71”
Long
Main
Hydraulic
Hoses 3/4” I.D. 3/4” I.D.
21