SPB-500 Safety & Operating Instructions
Sherpa Tools | SPB-500 | 2018
2
Please read and follow the following instructions carefully. This procedure will guide you
through the correct steps to assemble your wheel barrow and ensure safe use.
Step 0: The first charge of the battery will take between 8 to 24 hours, we recommend that
you start charging before assembling the wheelbarrow. Please refer to the section
“Charging and Caring for the Battery” on page 9for instructions.
Step 1
: Rest the base module with handle on the ground (
Figure 1
).Get 2 sets of rear wheels
and 2 sets of wing bolts and nuts ready (
Figure 2
).
Wing bolt: M8*P1.25*45mm x 2
Wing nut: M8*P1.25mm x 2
Step 2
: Insert one of the wheels into one side of the base unit tube. Align the holes (
Figure 3
)
so that the wing bolt can be put through (
Figure 4
). Fasten the bolt and nut and make
sure they are tight enough (
Figure 5
). Your half-assembled wheelbarrow should now
look like
Figure 6
.
Assembling the SPB-500 Wheelbarrow
Figure 1
Figure 2
Figure 3
Figure 4