C.
Attach the Steering Yoke (11) to the centre of the Front Axle Assembly using the washer and split-pin
(22) and washer already attached to the mounting post. Next secure the axle Support and steering link
connector using (19) bolts, (21) nuts, and (20) washers
(as shown in Figure 3).
NB only tighten the nuts to remove access slack in the thread and ensure free movement from
side to side. Shouldered bolts should be used on moving steering parts.
Figure 2. Figure 3.
STEP 4
Install the wheels in the following order:
1.
Smear a little oil or grease onto the axles.
2.
Place the wheels onto the axles with the valve
Stem facing outward.
3.
Use the 12mm washers (24) and Wheel Nuts (23)
STEP 5
Turn the cart upright onto its wheels.
STEP 6
Attach the front, back, left and right panels
using the large R Clips (26).
NOTE: Latch the side panels in the upright position
using the lock handles. Raise the handles to vertical
position, when the bracket is around the lock handle,
turn 180
o
to
secure.
Tighten the nuts on the lock handles to allow for
smooth operation while not being overly tight.
Содержание SLGT2
Страница 6: ......
