Installing Batteries
Open the battery compartment of the receiver and insert two“AAA”batteries with correct
polarity.Open the battery compartment of the transmitter and insert two “AAA”batteries
with correct polarity.
Turn ON/OFF unit
Press
button on the receiver to turn on/off the receiver.
Press
button on the transmitter to turn on/off the transmitter.
Synchronize/Pair Transmitter and Receiver
The transmitter and receiver were already paired at our manufacturing facility.Usually you
do NOT need to re-synchronize or re-pair the units.Your just plug in the probes,insert
batteries,turn on the receiver and the transmitter and wait for a few seconds,you will see
The temperature shown on both receiver and transmitter and the units are ready for use.
However,in some unusual cases,the transmitter and receiver are no longer paired,then you
May need to re-synchronize them by following the below steps:
1.Insert the stainless steel probes into the corresponding plugs in the transmitter.
a.
Turn on the transmitter by pressing the button.The transmitter will show the current
temperature on its LCD display.
2.Turn on the receiver by pressing the button.
3.Press and hold PROBE(按键图标) button on receiver for 2～3 seconds to enter the
synchronization
Mode which will last for 16 seconds.The signal icon(信号图标) will flashing.
4.Wait for moment until the temperature reading shows on the receiver display.it means
The synchronization/pairing is complete.Your professional remote cooking thermometer is
Now ready for use.
Note:The synchronization between the transmitter and the receiver won´t be lost even if you
replace the batteries.
Loss Link Alert
If the receiver is taken out of range or there is abnormal interference or after shutting off
the transmitter,the receiver may not be able to receive the transmission from the transmitter.If
this happens for over 2 minutes,the unit will alert you the signal is lost.
Pressing any button on Receiver will stop the Loss Link beep.
To regain transmission signal,move the receiver closer to the transmitter,the link should
Be automatically restored and the temperature should appear on the receiver display.
