8
The product must be installed and ready to work according to
the instructions.The product must be installed and used indoors, at
room temperaturenot exceeding 40 ° C.The product should not be
placed near any heat source or direct sunlight.The product should
be put in place with good air flow so it does not undergo overheating.
Do not cover and do not block the ventilation holes on the product.
They are necessary for proper air circulation inside the product.Do
not use this product near water, or in close proximity to the baths,
bowls or sink. Do not use it in a wet basement or near a pool.The
product does not come into contact with water or moisture. Moving it
from a cold to a warm causes its components moisture condenses.
It should be wait until the product is completely dry before it is
switched on again.In case of fire, do not use a water extinguisher to
extinguish it.The product should not be used during a lightning
storm. There is a risk of electric shock .Ethernet connector may only
be used to connect with devices that They support the same type of
interface. The cables used to connect may not go outside the
building, where the product installed.
Power source
Use only the power supply Class II supplied with this product.
The product should be powered from a source of the same type as
indicated on ozna ombined power supply.
AC adapter supplied with the product is the power source of limited
power, according to EN 60950-1 (2.5) and the standards of the
country in whichthe product is installed. Using another type of AC is
strictly prohibited.Plug the AC adapter is used as the main
disconnect device from the mains supply 230. Make sure that the
electrical outlet is easily accessible and isin
as close as possible
away
from the device
.
The decoder must be connected only to the
