05_51351_0B
Page 4
sTep 1
Fit together an end rib using the following parts (1) 10224 Bent Tube Swedged, (1) 10225 Bent Tube Plain and
(2) 10226 Bent Corner Leg. Using (2) 10114 1/4" x 2" Carriage Bolts and (2) 01010 1/4" Nuts securely fasten
the joints of the Corner Legs to the bends. Lay this rib on the ground at the rear of your shelters designated
location.
BAsIc FRAme AssemBlY
sTep 2
Assemble a middle rib using the following parts (1) 10224 Bent Tube Swedged, (1) 10225 Bent Tube Plain and
(2) 10273 Middle Upright Tube. Using (2) 10114 1/4" x 2' Carriage Bolts (1) 00669 1/4" x 3" Round Head Bolt
and (3) 01010 1/4" Nuts securely fasten the joints of the Corner Legs to the bends. Lay this rib on the ground
near the first end rib.
sTep 3
3A
Stand the rear end rib vertically and lean against a permanent structure. Place a ShelterLock against
the rib over the hole for the cross rail just above the joint of the side bend and the extension. Insert a 1/4" x 3"
Carriage Bolt through the rib and the ShelterLock with the head of the Bolt on the outside of the rib. Place athe
plain end of a 02030 Wind Brace using a 1/4" x 2" Carriage Bolt and Nut to each corner upright tube. Place (2)
10112 3-way Connectors around the bent corner leg. Insert the end of a 10110 Cover Rail Tube into the 3-Way
Connector and fasten these with a 1/4" x 1-5/8" Bolt and Nut. Slide the connector until it is 5" up from the
ground and loosely tighten. Repeat at the bent corner.
3B
Attach 10111 4-Way Connector to the end of the 2 Cover Rail Tubes and loosely fasten with a 1/4" x
1-5/" Bolt and Nut. Insert another Cover Rail Tube into each 4-Way Connector and loosely fasten with a 1/4"
x 1-5/8" Bolt and Nut. Place the plain end of another 02030 Cross Rail over swedged end of those already
attached and lean them down. With help, stand the middle rib vertically and insert the bottom of each upright
tube into the 4-Way Connectors. Place a ShelterLock against the rib over the hole for the Cross Rail just above
the joint of the side bend and extension. Insert a 1/4" x 3" Bolt through the rib and ShelterLock with the head of
the bolt on the outside of the rib. Raise the Cross Rails up and slide them over the bolt and rest them into the
anti-rack device and secure with 1/4" Nut. Attach the lower end of the Wind Brace to the middle rib with a 1/4" x
2" Carriage Bolt and Nut. Be sure that the head of the Bolt is on the outside of the rib. Slide the 4-Way Connec-
tor up until they are 5" above the ground and tighten losely.
