05_107153_0D
Page 4
Basic Frame Assembly
NOTE: FRAME EXTENSION kIT
22'x20'x13' is the base frame dimension. Your model may have more middle ribs than shown in the illustration on pg.2.
You will receive one extra rib for every extra 4 ft. of building length that you purchase. The basic frame assembly will
remain the same. The cover will be the correct size for the length of the building
1. PloTTInG THe FRAme:
2. ASSemBle end RIBS
3. ASSemBle mIddle RIBS
Before building your shelter, you should choose a flat area on your prop-
erty and plot your shelter.
1. Stake out the area for the shelter in the desired spot. The width of the
area should be at least equal to the width of the shelter and the length
should be equal to the length (“L”) of the shelter
Fig. 1
.
2.To be sure the staked area is square tie a rope diagonally from corner to
corner.
3.Measure from where the two ropes intersect each other to all 4 corners.
This measurement should be the same. If they are not equal the stakes
need to be adjusted until the width, length and inside measurements are
correct.
Assemble end ribs as shown in
Fig. 2
. Securely
fasten all of the joints with the hardware indicated.
Assemble middle ribs as shown in
Fig. 3
. Securely
fasten all of the joints with the hardware indicated.
Use #11131
5/16" x 2 3/4" L
Bolts
Use #11131
5/16" x 2 3/4" L
Bolts
A
B
BUILDING
LENGTH
22 ft.
WIDTH
Fig.1
Fig.2
Fig.3
11016
11019
11016
11019
04551
04551
04551
04551
11013
11013
11013
11013
11068
11068
11068
11068
11136
11135
11270
11270
4. ASSemBle WInd BRAceS
Assemble all of the wind braces as shown in
Fig. 4
.
Securely fasten the joints with the hardware indicated.
Fig. 4
11193
11095
800053
00648
00690
00690
