Assembly Instructions
14 X 32 Party Tent Style
V1.0 14 X 32 Size
Do NOT Return Unit to Store or Dealer. For all Questions or Shortages please call MDM Products LLC directly.
For Customer Service 800-447-7079 or 203-380-2703 8 AM – 5 PM EST
SITE PREPARATION
Select a level or as close to level as practical location for
your ShelterKing Party Tent. The unit should be placed on
a base for the intended use, usually grass or soft surface.
The unit should not be located under trees, which will shed
hard fruit such as apples, walnuts, or heavy pine cones.
The cover of your unit will protect against light leaves or
debris, however large branches or other falling items may
cause puncture or tears in the cover material.
Take notice of drainage both around your intended
location. Water draining from the surrounding terrain
should be planned so that it does not run into the unit.
Check to be certain that adequate clearance is allowed for
entry and exit from ends of unit. Party tent should not be
installed close to buildings or other obstructions that would
prevent exit in the event of an emergency.
FRAME ASSEMBLY
Read the complete instructions guide before starting to
assemble party tent. Familiarize yourself with each of the
component parts. These are itemized for easy
identification. Some parts are similar and vary only in
shape or size so be sure you use the correct ones where
stated.
Identify the Corner and Interior Straight Upright Leg Poles
(items #1 & 2). These and all have pre-drilled holes at the
bottom for securing the feet plates. The number of Interior
Straight Uprights will vary by the size of the Party Tent.
The 4 corner leg poles (#2) have additional holes at the
top, which will be used for attaching the roof cover to the
legs with the use of the attached “S” hooks.
Insert the leg poles (#2) into the white plastic feet plates
(#12) so that the base holes align with the corresponding
ones in the feet. Use a 2-3/8” hex bolt (#14) with a washer
(#15) and pass it through the aligned holes. Use one more
washers on the threaded side of the bolt as needed. Use
a lock nut and tighten. Do not over tighten and damage
either upright leg or plastic foot. Repeat for all legs and
place aside until needed.
Lay out all the parts as shown in the Frame Component
Diagram so that they are roughly in their correct places.
There are 4 different types of Connectors (#5, 6, 7, & 8).
Those with a sharp bend (#7 & 8) connect the Leg Poles to
the Rafter (#4) and Cross Poles (#3). Those with a
shallow bend (#5 & 6) connect the Rafter & Cross Poles at
the ridge of the tent. These connectors are either 3 or 4
way types. The 3 way connectors of both types (#5 & 7)
are to be used at each end of the party tent frame.
Frame Connector Types
Frame Component Diagram
#7
#8
#5
#6
