36 |
P a g e
OPERATION
S
ET THE
T
IMER
Perform the steps below to program a timed shaking process.
End of Procedure
1.
Turn on the Timer
Verify the lid is completely closed.
Place the Timer switch in the ( I ) ON position.
•
The platform will stop shaking until a value greater
than 0 has been programmed.
2.
Access the Timer Adjustment mode
Briefly push and release either the
Up
or
Down
arrow
button to access the Timer adjustment mode.
•
The display will briefly flash the letters “SP”, then
show the flashing, adjustable timer value.
Note:
The display automatically exits the adjustment mode after 5
seconds of inactivity, with the last shown timer value saved.
Timer Adjustment
Mode
Initial Timer Value
3.
Program the new Timer value
Use the
Up
and
Down
arrow buttons to program the desired
number of minutes, up to a maximum of 999 minutes.
New Timer Value
4.
Wait 5 seconds after entering the number of minutes
•
The display will stop flashing.
•
The platform will start shaking.
•
The timer will automatically begin counting down.
End of Countdown
•
When the countdown reaches 0, the shaking
platform stops moving.
•
The TIMER alarm sounds and the light illuminates.
Push the Mute button to silence the alarm.
•
The TIMER light remains on until the TIMER switch is
turned off.
Note:
Lid openings interrupt the shaking process but will
not pause the
timed countdown
. Closing the lid resumes the shaking process.
Countdown Complete
TIMER
