Shel lab SCO10A, Руководство по установке и эксплуатации

Страница: 15 / 60

15 | P a g e
INSTALLATION
I
NSTALLATION
P
ROCEDURE
C
HECKLIST
For installing the unit in a new workspace location.
Pre-Installation
 Verify a CO
2
gas supply source suitable for your application is
available and can be connected to the incubator, page 9.

Check that the required ambient conditions for the unit are met,
page 16.
 Check that the spacing clearance requirements are met, page 16.
•
Unit dimensions may be found on page 52.
 Check that a suitable electrical outlet and power supply is present,
page 17.
Install the incubator in a suitable location

Review the lifting and handling instructions, page 18.

Install the unit leveling feet, page 18.

Install the incubator in its workspace location, page 19.
Set up the incubator for use
 Clean and disinfect the unit and accessories (except the HEPA
filter), page 19.

Install the chamber HEPA filter and ceiling air duct in the
incubation chamber, page 20.
 Install the shelving, page 21.
 Connect the incubator to the CO
2
gas supply source, page 22.
 Verify that the silicone stopper is installed in the access port
inside each incubation chamber, page 23.