3
Display Control Instruction
1. Add (DMX512 address setting page menu)
(1)
DMX address
this option is used to set the DMX communication address. Press the "up" key to
increase the address number, and the "down" key to decrease the address number. After selecting the
address, press "enter" to save and exit.
2. Set (this option enters system setting)
(1)
Run mode
this option is used to set the working mode of the lamp body. Press "enter" to enter the
setting, press "up" or "down" to select the working mode. The working mode successively includes "DMX" /
DMX512 mode, "autol1" / self running mode 1, "autol2" / self running mode 2, "sound" / s voice control mode.
After selecting the working mode, press "enter" to save and exit.
(2)
Channel mode
this option is channel setting. Press "enter" to enter the setting, press "up" or
"down" to select channel mode.
(3) Invert LCD this option is to set the LCD font reverse direction of the display panel. Press "enter" to enter
the setting, press "up" or "down" to select the switch.
(4)
Invert pan \ invert tilt
this option is to set the X / Y axis in the reverse direction. Press enter to
enter the setting, up or down to select whether the X / Y axis is in the reverse direction. Select on to indicate
that the X / Y axis is in the reverse direction, off to indicate that the X / Y axis is not in the reverse direction.
Press enter to save the exit.
(5)
Pan tilt swap
this option is the X / Y vertical switch setting, press "enter" to enter the setting, press
"up" or "down" to select the X / Y axis vertically, select "on" to indicate the X / y vertical opening, select "off"
to indicate the X / Y axis vertical closing, press "enter" to save and exit after selecting the direction.
(6)
Encoder
this option is the X / y error correction switch. Press "enter" to enter the setting, press "up"
or "down" to select, select "on" to indicate that the X / y error correction function is on, select "off" to
indicate that the X / y error correction function is off, and press "enter" to save and exit.
(7)
No signal
this option is whether to keep the previous working state when the lamp has no signal.
Press "enter" key to enter the setting, press "up" key or "down" key to select the lamp state. Select "clean"
to clear the previous working state when the lamp has no signal input, and automatically restore the initial
state when the power on reset is completed. Select "keep" to indicate that the lamp has no signal No. will
remember the previous working state when entering, keep the previous working state unchanged, and press
