- 3 -
OPERATION
1. Place food onto the tray. NOTE: The tray is double-sided:
one side is a flat tray, the other side is a deep tray.
2. Screw the Auto-Vacuum Machine on top of the dome,
securing it with the Vent Cap.
3. Cover the tray with the dome, ensuring that the rim is clean
and free of any debris that may hinder the suction process.
4.
COMLETELY PRESS
downward on the
ON
button. The suction
process with begin and continue until optimum pressure is
achieved (approximately 3 to 6 minutes).
5. Press down on the dome for at least 10 seconds during
vacuuming to ensure secure contact with the tray. When
optimum pressure is achieved, the vacuum will automatically
stop.
6. To open,
COMPLETELY PRESS
the
OFF
button to release the
vacuum. This may take up to 10 seconds.
NOTE:
The Auto-Vacuum Machine has a built-in sensor to monitor the level of vacuum pressure. If
the vacuum level drops, the suction process will begin again to restore the optimum vacuum level.
PRO TIP:
This device can be also used without the tray, i.e., on a table or countertop with a flat,
smooth surface.
CAUTION
• This device is not a substitute for refrigeration, canning or freezing.
• This device cannot reverse the deterioration of food. It can only slow down the process by
maintaining food quality for longer time.
• For best results, avoid humidity and be sure there is no water or dampness inside the dome.
CLEANING AND MAINTENANCE
• Wipe with a damp cloth and mild soapy solution if needed.
• Do not use abrasives or petroleum-based detergents.
• Do not immerse in water.
• Do not place Auto-Vacuum Machine in dishwasher (tray IS dishwasher safe).
• Keep away from open flames and extreme heat.
• Make sure vent is unblocked during use.
• Keep out of reach of children at all times.
• Do not attempt to disassemble or repair this device. There are no userserviceable parts.
• Please check and clean the air filter when you replace the batteries (see illustration).
• Do not use the handle to swing or shake the device.
• The weight of contents should not exceed 4.4 lbs. (2Kg).
TROUBLESHOOTING
If the device is not working, please check the following:
• Are the batteries fresh and inserted correctly?
• Is the table surface smooth?
• Is the dome surface clean and free of any debris that could hinder the suction process?
• Are you pressing the
ON/OFF
buttons completely?
IMPORTANT – FOR BEST RESULTS
• The Vent Cap must be securely fastened to the lid.
• Always keep the edges of the tray and the dome clean and free of any debris that could hinder
the suction process.
A
B
C
E
F
G
H
6
