- 2 -
CLEANING AND MAINTENANCE
•
Always remove batteries from the slippers before cleaning
•
Spot clean with a damp cloth or hand wash in cold water with mild detergent
•
Hang dry
•
Do not twist the garment to prevent damaging the cable
•
Do not dry clean or bleach
OPERATION (CONT’D)
6. When fully charged, disconnect the batteries from the charger.
7. Locate the input plugs inside the small pouch on the outside
of each slipper and connect the charged batteries. Place the
batteries into the pouch once connected.
8. Press and hold the control button on the side of each slipper
for three to five seconds, or until the LED light flashes red,
then green, then blue.
9. The LED light on the control button of the slippers will then only
flash red, indicating that the shoes are in pre-heat mode.
10. After approximately five minutes, the light will change to solid
red, indicating the slippers are no longer in pre-heat mode. The temperature can be adjusted
by pressing the control button.
¬ Blue: Low heat – 104 °F with approximate run time of 4-5 hours
¬ Green: Medium heat – 113 °F with approximate run time of 2.5-4 hours
¬ Red: High heat – 122 °F with approximate run time of 2-3 hours
NOTE: Recommended to wear socks inside of the slippers.
11. To turn off the slippers, press and hold the control button for three to five seconds,
or until the LED light turns off.
12. Unplug the batteries when the slippers are not in use. Store batteries inside the pouch
of the slippers.
NOTE: The Heated Indoor/Outdoor Slippers should only be used with the included batteries
and charging cable. Never use the batteries or cable with any other device, regardless of how
similar the plugs may look, feel, or appear to fit or work together.
BATTERY WARNINGS
•
Do not use batteries if you notice a change of shape (lumps), overheating when charging,
or if rust or corrosion on the battery connectors is found.
•
Charge the batteries regularly (recommended a minimum of once every 3 months).
•
Charge between each use.
(CONTINUED ON NEXT PAGE)
