Sharp XL-HP550E, Руководство по эксплуатации

Страница: 16 / 36

02/8/7 XL-HP550E(E)2.fm
16
XL-HP550E
Ba
sic Ope
ration
Setting the clock
The clock should be set on the main unit.
In this example, the clock is set for the 24-hour (0:00) display.
To confirm the time display:
Note:
The "CLOCK" or time will flash at the push of the CLOCK button
when the AC power supply is restored after a power failure or
unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the time display is flash-
ing, step 3 (for selecting the 24-hour or 12-hour display) will be
skipped.
To change the 24-hour or 12-hour display:
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK button on the main unit and within 5 sec-
onds, press the MEMORY/SET button.
3
Press the TUNING/TIME ( or ) button to select 24-hour
or 12-hour display and then press the MEMORY/SET but-
ton.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"AM 0:00" The 12-hour display will appear.
(AM 0:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it
has been reset. [Refer to "Clearing all the memory (reset)" on
page 31 for details.]
4
Press the TUNING/TIME ( or ) button to adjust the hour
and then press the MEMORY/SET button.
!
Press the TUNING/TIME ( or ) button once to advance
the time by 1 hour. Hold it down to advance continuously.
!
When the 12-hour display is selected, "AM" will change au-
tomatically to "PM".
5
Press the TUNING/TIME ( or ) button to adjust the min-
utes and then press the MEMORY/SET button.
!
Press the TUNING/TIME ( or ) button once to advance
the time by 1 minute. Hold it down to change the time in 5-
minute intervals.
!
The hour will not advance even if minutes advance from "59"
to "00".
Press the CLOCK button on the main
unit or remote control.
The time display will appear for about 5
seconds.
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 31 for details.]
2 Perform "Setting the clock" from step 1.