Sharp XL-E15H, Руководство по эксплуатации

Страница: 22 / 24

XL-E15H_OM_EN.fm
E-15
2009June30
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet (CD
pickup, etc.) or on the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on with no disc in the unit until normal playback is
possible (about 1 hour). Wipe off any condensation on the
transmitter with a soft cloth before operating the unit.
When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.
If such a problem occurs, do the following:
1
Set the unit to the stand-by mode and turn the power on again.
2 If the unit is not restored in the previous operation, unplug and
plug in the unit, and then turn the power on.
Note:
If neither operation above restores the unit, clear all the memory by
resetting it.
1 Press the ON/STAND-BY button to enter the power stand-by
mode.
2 Press and hold TUNING/FOLDER and press ON/STAND-BY
button on main unit. “RESET” appear.
Caution:
This operation will erase all data stored in memory including clock,
timer setting, tuner preset and CD programme.
Remove all CDs from the unit. Make sure there is no CD in the disc
tray. Then, set the unit to the power stand-by mode. Carrying the unit
with discs left inside can damage the unit.
Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD
collection and player.
z Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
z Keep your discs away from direct sunlight, heat, and excessive
moisture.
z Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.
„ General
Symptom Possible cause
z The clock is not set to
the correct time. z Did a power failure occur?
Reset the clock. (Refer page 7)
z When a button is
pressed, the unit does
not respond. z Set the unit to the power stand-
by mode and then turn it back
on.
z If the unit still malfunctions,
reset it. (Refer page 15)
z No sound is heard. z Is the volume level set to
“MIN”?
z Are the headphones
connected?
z Are the speaker wires
disconnected?
„ CD player
Symptom Possible cause
z Playback does not start.
z Playback stops in the
middle or is not
performed properly.
z Is the disc placed upside
down?
z Does the disc satisfy the
standards?
z Is the disc distorted or
scratched?
z Playback sounds are
skipped, or stopped in
the middle of a track. z Is the unit located near
excessive vibrations?
z Is the disc very dirty?
z Has condensation formed
inside the unit?
„ Remote control
Symptom Possible cause
z
The remote control does
not operate.
z
Is the AC power lead of the unit
plugged in?
z Are the batteries polarity
correct?
z Are the batteries dead?
z Is the distance or angle
incorrect?
z Does the remote control sensor
receive strong light?
„ Tuner
Symptom Possible cause
z The radio makes
unusual noises
continuously. z Is the unit placed near the TV or
computer?
z Is the FM aerial or AM loop
aerial placed properly? Move
the aerial away from the AC
power lead if it is located
nearby.
„ Condensation
„ If problem occurs
„ Factory reset, clearing all memory
„ Before transporting the unit
„ Care of compact discs
YES
Correct
NO