Sharp XG-V10XU - Conference Series XGA LCD Projector, Руководство по обслуживанию

Страница: 36 / 182

36
XG-V10XU
No. Adjusting point Adjusting conditions Adjusting procedure
S4 "
Delivery setting 4
"
Remote controller
setting
Process
adjustment
»
Make the following settings.
34 Lens perform-
ance checking
»
Using the set's control switch or the remote control-
ler, make sure the focus, zoom, keystone and lens
shift actions are as specified.
35 Delivery set-
tings 1. When the S4 delivery set-
tings have been made, the
SET-UP signal is accept-
able.
If the process mode is
called up again, however,
the SET-UP signal is not
automatically accepted. In
such case, select Group:
VIDEO1 and Subject: SET
UP, change the SET UP
setting from 0 to 1, and exit
from the process mode. Or
make the S4 delivery set-
tings again.
The methods of color correction adjustment, after LCD panel is replaced.
When not use color correction system.
No. Adjusting point Adjusting conditions Adjusting procedure
1. Make the following choice.
Group : NOKO
Subject : CC
»
If the color is irregular, adjust the setting NOKO-G
or NOKO-R to minimize the right-hand and left-hand
color irregularity.
»
If there is no color irregularity, turn off the saw-tooth
correction using SW4201 (green) and SW4202 (red).
1 Color correction
Rest
»
Make the following setting.
Subject : CC
Setting : 0 (color correction OFF)
1. Feed the gray only RGB
color signal. (XGA 60Hz)
2. Check for uneven color spot
on the screen.
3. Make the following choice.
Group : NOKO
Subject : NOKO-G
Choose the subject NOKO-
R for the R Color.
2 Saw-tooth wave
Correction (G),
(R)