Sharp XG-SV100W, Руководство по эксплуатации

Страница: 60 / 92

56
Auto Power Off
Auto Restart
COMPUTER2 Select
STANDBY Mode
RS-232C
Off
Normal
Monitor Output
On
Standard
9600bps
On
Disable
On
SEL./ADJ.
RETURN ENTER
END
Fan Mode
Sysem Lock
DLP
®
Link™
DLP
®
Link™ Invert
Memory Menu
Rotate Indicator
All reset
Lamp Timer (Life) [ 0]h [ 0] min ( 100%)
Picture Audio SIG SCR PRJ Net.
H
T
Z
1
Auto Power Off Function
Selectable
items
Description
On The projector automatically enters
the standby mode when no input
signal is detected for 15 minutes or
longer.
Off The Auto Power Off function will
be disabled.
When the Auto Power Off function is set to
“On”, 5 minutes before the projector enters the
standby mode, the message “Enter STANDBY
mode in X min.” will appear on the screen to
indicate the remaining minutes. •
Note
2
Auto Restart Function
Selectable
items
Description
On If the power cord is unplugged
from the outlet or the breaker
switch is turned off when the
projector is on, then the projector
automatically turns on when the
power cord is plugged into the AC
outlet or the breaker switch is
turned on.
Off The projector does not turn on
automatically when the power
cord is plugged into the AC outlet
or the breaker switch is turned on.
3
COMPUTER2 Select
You can also use the MONITOR OUT terminal
as the COMPUTER/COMPONENT 2 terminal.
Select whether to use the terminal as an input
terminal or output terminal.
Selectable items Description
Input The terminal can be used as an
input terminal (COMPUTER/
COMPONENT 2).
Monitor Output The terminal can be used as an
output terminal (MONITOR OUT).
Set this before connecting the external
equipment.
The setting cannot be changed when Input
mode is “COMPUTER 2”. •
•
Note
4
STANDBY Mode
When set to “Eco”, power consumption is
reduced in Standby mode.
Selectable items Description
Eco The monitor output, RS-232C and
Network functions are switched off in
Standby mode.
Standard The monitor output, RS-232C and
Network functions are activated even
if the projector is in Standby mode.
5
Selecting the Transmission
Speed (RS-232C)
Make sure that both the projector and com-
puter are set for the same baud rate.
Selectable items Description
9600 bps Transmission speed is slow.
Transmission speed is rapid.
38400 bps
115200 bps
Refer to the “SETUP MANUAL” contained on
the supplied CD-ROM for RS-232C
Specifi cations and Command Settings.
Refer to the computer’s operation manual for
instructions for setting the computer’s baud rate. •
•
Note
Helpful Functions Set during Installation (“PRJ” menu)
Menu operation
n
Page 46