XE-A201UC
– 11 –
CHAPTER 8. ONLINE APPLICATION
1. ONLINE PRESET
1. PGM Preset
[JOB #30] MRS = 000001
Programming of the terminal number
PGM mode
[JOB #31] MRS = 00
Programming of the transmission control
If the specification of direct connection is used, this programming must
be not changed.
PGM mode
31-A: Not used
[JOB #32] MRS = 05
Programming of the transmission data rate (Baud rate)
PGM mode
[JOB #33] MRS = 002013
Programming of the start end code
If “000” is specified for each of the codes, the data block is provided
with neither the start code nor the end code.
PBM mode
When master resetting is taken, “002013” is specified.
This means that the data block is provided with the start code 02h
(STX) and the end code 0Dh (CR).
Enter both the codes in decimal digits.
Any figures greater than 127 can not be specified for start and end
codes.
[JOB #35] MRS = 007
Programming of the timeout time
PGM2 mode
Job #
PGM-MODE programming for online operation
30
Programming of the terminal number
31
Programming of the transmission control
32
Programming of the baud rate
33
Programming of the start and end code
35
Programming of the timeout time
31-B:
Transmission line form
31-B
Half duplex system
1
Full duplex system
0
30
X
XXXXXX
XXXXXX : Terminal number
ST
ST
TL
000000
MRS = 000001
It is set to "000001" when master resetting is taken.
31
X
AB
ST
ST
TL
00
32-A:
Transmission data
32-A
Print data send
1
RAM data download and upload
0
32-B:
Transmission baud rate
32-B
2400 bps
6
4800 bps
5
9600 bps
4
19200 bps
3
32
X
AB
ST
ST
TL
33
X
XXXYYY
XXX : Start code
YYY : End code
ST
ST
TL
000000
35
X
XXX
XXX : Time out time (1-255 sec)
ST
ST
TL
