Sharp VC-H998U, Руководство по эксплуатации

Страница: 10 / 10

Setting the 3
↔
4 Output Channel Selector
The 3
↔
4 OUTPUT CHANNEL selector changes the VCR OUTPUT to standard
TV broadcasting signals. Both your TV and VCR must be set to the same
channel (i.e. TV on channel 3 and VCR OUTPUT CHANNEL selector on 3).
Your VCR is set to channel 3 at the factory, so your TV should be tuned to
channel 3 as well. If channel 3 is an active broadcast channel in your area, set
the VCR 3
↔
4 OUTPUT CHANNEL selector to 4 and tune your TV to channel 4.
Connecting the VCR
Each type of antenna and TV system requires a different method of connection. If you have cable TV (CATV),
see page 43 for Cable TV connection.
To determine the correct type of connection, first check the type of antenna and TV terminal in use.
Make the connections as shown below.
• Consult your SHARP Dealer or Service Center for the type of adaptor, separator, transformer or combiner that might be
required.
After the Connection
Plug in the power cords of the VCR and TV. Then go to the following Setting Up section.
ANT/CABLE
Antenna type
Combined VHF/UHF
antenna cable
VCR Rear
Separate VHF/UHF
antenna cable
Type of TV Terminal
UHF
VHF
VHF
UHF
U/V IN
UHF
VHF
or
or
VHF/UHF antenna
cable or adaptor
UHF flat twin-lead
antenna cable
Supplied
coaxial
cable
(separator, not
supplied)
(combiner, not
supplied)
VHF coaxial
antenna cable
Connect the flat twin-lead cable to a
transformer (300 Ohm to 75 Ohm,
not supplied)
U/V IN
UHF
VHF
VHF MATCHING BOX
75
Ω
300
Ω
Connect the round
coaxial cable to a
transformer
(75 Ohm to 300 Ohm, not
supplied)
(separator, not
supplied)
VHF
UHF
3
↔
4 OUTPUT CHANNEL
selector
Rear of Your VCR
Selecting the Video Channel on Your TV
To view the output of your VCR on your TV, you must select the video channel (3 or 4) on your TV that
corresponds with the output channel set above.