Sharp UA-PG50E, Руководство по эксплуатации

Страница: 14 / 104

E-10
TROUBLESHOOTING
SYMPTOM REMEDY (not a malfunction)
Odours and smoke are not
removed.
• Clean or replace the fi lters if they appear to be heavily soiled.
(Ref. E-8,E-9)
The DUST AND ODOUR SIGN
illuminates green even when the air
is impure.
• The air could be impure at the time the unit was plugged in.
Unplug the unit, wait one minute, and plug the unit in again.
The DUST AND ODOUR SIGN
illuminates orange or red even
when the air is clean.
• Sensor operation is aff ected if the odour sensor and dust sensor
fi lter are dirty or clogged. Gently clean the odour sensor and
dust sensor fi lter. (Ref. E-9).
A clicking or ticking sound is heard
from the unit.
• Clicking or ticking sounds may be audible when the unit is
generating ions.
The discharged air has an odour.
• Check to see if the fi lters are heavily soiled.
• Clean or replace the fi lters.
• Plasmacluster Air Purifi ers emit small traces of ozone which may
produce an odour. These ozone emissions are well below safety
level.
The unit does not operate properly
when cigarette smoke is in the air.
• Is the unit installed in a location that is diffi cult for the sensor to
detect cigarette smoke?
• Is the dust sensor fi lter blocked or clogged?
(In this case, clean the fi lter.) (Ref. E-9)
The DUST AND ODOUR SIGN is
turned off .
• Check to see if the Lights OFF Mode is selected.
Press
for 3 seconds to turn light ON.
(Ref. E-7)
• Check to see if the SLEEP mode is selected.
The DUST AND ODOUR /PLASMACLUSTER SIGN are turned off
automatically after the SLEEP mode is selected.
The DUST AND ODOUR SIGN
changes colour frequently.
• The DUST AND ODOUR SIGN automatically changes colours
as impurities are detected by the dust sensor and odour sensor.
The sensor detection sensitivity can be adjusted lower.
(Ref.E-7)
Before calling for service, please review the Troubleshooting list below, since the problem may not
be a unit malfunction.