3
Household use only
Thank you very much for buying this SHARP product. Before using your SHARP refrigerator,
please read this operation manual to ensure that you gain the maximum benefit from it.
This refrigerator contains flammable refrigerant (R600a:
■
isobutane) and insulation blowing gas (cyclopentane).
Observe the following rules to prevent ignition and explosion.
The refrigeration system behind and inside the refrigerator
•
contains refrigerant. Do not allow any sharp objects to
come into contact with the refrigeration system.
Do not use mechanical devices or other means to
•
accelerate the defrosting process. (This refrigerator has
adopted automatic defrosting system.)
Do not use electric appliances inside the refrigerator.
•
Use only the specified parts for the refrigerator
•
compartment light.
Do not block the openings on the circumference of the
•
refrigerator.
Do not use flammable sprays, such as spray paint near
•
the refrigerator. It may cause explosion or fire.
If the refrigeration system should get punctured, do not
•
touch the wall outlet and do not use open flames. Open
the window and air out the room. Then ask a service
agent approved by SHARP for servicing.
This refrigerator should be disposed appropriately.
•
Take the refrigerator to a recycling plant for flammable
refrigerant and insulation blowing gases.
Do not store highly volatile and flammable materials such
■
as ether, petrol, propane gas, aerosol cans, adhesive
agents and pure alcohol etc.
These materials are liable to explode.
Dust deposited on the power plug may cause fire. Wipe it
■
off carefully.
Do not attempt to change or modify this refrigerator. This
■
may result in fire, electric shock or injury.
Ensure that the refrigerator presents no danger to children
■
while being stored for disposal. (e.g. remove the magnetic
door seals to prevent child entrapment.)
WARNING
CAUTION
Attention about Power supply:
■
Do not use an extension cord or adapter plug.
•
Make sure that the power cord has not been damaged
•
during installation or moving. If the power plug or cord
is loose, do not insert the power plug. There is a risk of
electric shock or fire.
Disconnect from the mains electricity supply by removing
•
the mains plug from the electricity supply socket. Do
not remove by pulling the mains lead. This may cause
electric shock or fire.
Should the flexible supply cord be damaged, it must be
•
replaced by a service agent approved by SHARP as a
special cord is required.
Do not touch the compressor unit or its peripheral parts,
■
as they become extremely hot during operation and the
metal edges may cause injury.
Do not touch foods or metal containers in the freezer
■
compartment with your wet hands. This may cause frostbite.
Do not place bottled and canned drinks in the freezer as
■
they may crack or explode when frozen.
In case of gas leak, ventilate the area by opening a
■
window, etc. Do not touch the refrigerator or the power
outlet.
Do not place objects containing liquid or unsteady objects
■
on top of refrigerator.
This refrigerator is not intended for use by persons
■
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the refrigerator by a person responsible
for their safety. Young children should be supervised to
ensure that they do not play with the refrigerator.
INSTALLATION
WARNING
Do not install the refrigerator in a damp or wet
■
location as this may cause damage to the insulation
and create a leak . Condensation may also build on
the outer cabinet and cause rust .
1
Keep adequate ventilation space around the refrigerator.
The figure shows the minimum required space for
•
installing the refrigerator. The amount of space
around the refrigerator affects the amount of power
consumption.
Insufficient spacing will decrease cooling efficiency
•
and increase energy consumption.This may reduce
the life of the unit and void warranty.
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned firmly and flat on the floor.
3
Remove the 2 screws of the cabinet lower part, and
then set the foot cover (supplied inside the refrigerator
compartment) with removed 2 screws.
4
Connect the power plug to a 230/240 volt. 10 amp.
power point.
NOTE
Position your refrigerator so that the plug is accessible.
•
Keep your refrigerator out of direct sunlight.
•
Do not place next to heat generating appliance.
•
Do not place directly on the ground. Provide suitable stand.
•
If the mains power is switched on when the door is open, the
•
door alarm will sound. Close the door to stop the alarm.
60 mm
or more
60 mm
or more
90 mm
or more
1400 mm
1525 mm
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
When transporting
The casters allow the refrigerator to move back and forth.
•
Carry the refrigerator by holding the handles located on the
•
rear and the bottom.
Foot cover
Free standing type
Screw
(2 screws)
Casters (4 pcs .)
rear
bottom
Adjustable foot
(B344).indb 3
2012/05/28 9:46:38
