OVEN
1.
Door
2.
Door
hinges
3.
Oven
lamp
4.
Waveguide cover (DO NOT REMOVE)
5.
Control panel
6.
Coupling
7.
Door
latches
8.
Oven cavity
9.
Door seals and sealing surfaces
10.
Door safety latches
11.
Ventilation
openings
12.
Outer
cabinet
13.
Power supply cord
14.
Door
opening
button
ACCESSORIES:
Check to make sure the following accessories are
provided:
(
15
) Turntable (
16
) Turntable support (
17
) Coupling
Place the turntable support in the centre of the oven
floor so that it can freely rotate around the coupling.
Then place the turntable on to the turntable support
so that it locates firmly into the coupling.
To avoid turntable damage, ensure dishes and
containers are lifted clear of the turntable rim when
removing them from the oven.
NOTE:
When you order accessories, please mention
two items: part name and model name to your
dealer or SHARP authorised service agent.
13
12
11
10
8
9
6
4
7
1
2
3
5
14
15. Turntable
(glass)
17. Coupling
16. Turntable
support
S
E
I
R
O
S
S
E
C
C
A
D
N
A
N
E
V
O
3
1. Remove all packing materials from the oven cavity,
(do not remove the waveguide cover)
, and the feature
sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned
door, damaged door seals around the door or dents inside the oven cavity or on the door. If there is any
damage, please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY
SHARP and repaired, if necessary.
2. Accessories provided
1) Turntable 2) Roller stay
3) Operation manual and Cooking guide
4. This oven is designed for countertop or cabinet use as well. It should not be installed in any area where
excessive heat and steam are generated, for example, next to a conventional oven unit. The oven
should be installed so as not to block ventilation openings. Allow a space of at least 10 cm on the top,
5 cm on both sides and at the rear of the oven for adequate air circulation. When installing in a cabinet,
the minimum inside dimension of the cabinet should be 5
mm (W) x 3 5 mm (H) x
mm (D). This
oven is not designed for built-in installation.
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in an
emergency.
5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal
injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230 – 240V, 50Hz.
6. This appliance must be earthed.
7. Operate the oven from a general purpose domestic outlet.
If a generator is used, do not operate the oven with non-sinusoidal outputs.
INSTALLATION
INSTRUCTIONS
42
5
377
3. Ensure
.
hat the coupling is installed.Place the turntable support on the oven floor, then place the
turntable onto the turntable support and coupling, ensuring it is located firmly. Refer to the diagram
ab ve
o
NEVER operate the oven without the turtable.
t
