5
INSTALLATION (Continued)
5.Make sure the power supply cord is undamaged
(see below) and that it does not run under the oven
or over any hot or sharp surfaces.
6.The socket must be readily accessible so that it can
be easily unplugged in an emergency.
7.Do not use the oven outdoors.
BUILDING-IN-KIT
An installation frame is available which enables the
microwave oven to be integrated within a kitchen unit.
The microwave oven is not designed to be built above
or near a conventional oven.
SHARP recommend the use of the build in kit,
EBR-47ST
, available from your SHARP dealer. Only
the use of this frame will guarantee the quality and
safety of the oven. When building, follow installation
instructions supplied carefully.
IMPORTANT ELECTRICAL CONNECTION
• Do not allow water to come into contact with the
power supply cord or plug.
• Insert the plug properly into the socket as the plug
may otherwise overheat and catch fire.
• Do not connect other appliances to the same socket
using an adaptor plug as it may cause the house
wiring to overheat and catch fire.
• If the plug or socket is loose or the power supply
cord is damaged, it must be replaced with a special
cord. The exchange must be made by an authorised
SHARP service agent. A defective plug, power
supply cord or socket may overheat and catch fire
during operation or cause an electrical shock.
• When removing the plug from the socket always
grip the plug, never the cord as this may damage
the power supply cord and the connections inside
the plug.
• The product is fitted with a re-wireable plug. Should
it not be suitable for the socket outlet in your home,
remove the plug and fit an appropriate type,
observing the wiring code on page 62.
If you wish to remove or replace the plug supplied,
ensure the plug is removed properly and not cut off.
When replacing the plug please ensure that you use a
BSI or ASTA approved plug to BS1363, this should be
fitted with a brown coloured 13 amp fuse approved
by BSI or ASTA to BS1362. If you have any doubt
about electrical connection seek the help of a
qualified electrician.
WARNING - IMPORTANT NOTE
Please note both the Operation Manual and Cookery
Book supplied specify 900W (IEC 60705) microwave
output power. This applies only when the oven is
operated on a 230-240V supply.
If your supply is less than 230-240V, it may be
necessary to increase the cooking time when
following the Operation Manual and Cookery Book
instructions.
THIS APPLIANCE MUST BE EARTHED
To wire an appropriate plug, follow the
wiring code on page 62.
WARNING:
BEFORE OPERATION
Plug in the oven.
1.
The oven display will flash the message shown
opposite.
2.
Press the
STOP/CLEAR
key.
3.
Set the clock, refer to the next page.
4.
Heat the oven using the top and lower grills without
food for 20 minutes. (For operation, see NOTES
on page 11).
Use the STOP/CLEAR
key to:
1
. Erase a mistake during programming.
2.
Stop the oven temporarily during cooking.
3.
Cancel a programme during cooking, press twice.
STOP/CLEAR
key
R- 83STM Op Man/Ck Bk 12/1/2000 11:27 Page 5
Содержание R-83STM
Страница 2: ...R 83STM Op Man Ck Bk 12 1 2000 11 26 Page B ...
Страница 67: ...R 83STM Op Man Ck Bk 12 1 2000 11 29 Page 65 ...