25
POSSIBLE CAUSE
Check the oven is plugged in.
Plug in another appliance to check the mains supply is feeding the socket.
Replace the fuse.
When oven is working, air circulates within the cavity. The door does not form an
airtight seal so air may escape from the door.
The oven cavity will normally be colder than the food being cooked, and so steam
produced when cooking will condense on the colder surface. The amount of steam
produced depends on the water content of the food being cooked. Some foods,
such as potatoes have a high moisture content. Condensation trapped in the door
glass should clear after a few hours.
Arcing will occur when a metallic object comes into close proximity to the oven
cavity during cooking. This may remove some of the paint and possibly roughen
the surface of the cavity, but would not otherwise damage the oven. Bare metal
should be touched up with acrylic paint to prevent the formation of rust.
Ensure all “eyes” are removed and stand directly onto the turntable or in a heat
resistant flan dish or similar.
Check the door is closed properly.
Ensure correct mode and power level has been selected.
The cooking fan generates noise.
The microwave energy pulses ON/OFF during cooking/defrosting.
PROBLEM
Digital display does not
light-up.
Draught circulates around
the door.
Flashing or arcing from
within the cavity when
cooking.
Arcing potatoes.
Control panel buttons do
not operate.
Oven cooks too slowly.
Oven makes a noise.
Condensation forms in the
oven, and may drip from
the door.
The wires in the mains cable are colour coded as
shown opposite:
As the colours of the cores in the mains lead of your
oven may not correspond with the coloured marking
identifying the terminals in your plug, connect the
wires as shown opposite:
Make sure the terminal screws are tight and the cable
is held securely by the cable grip where it enters the
plug. Like most appliances in your home, your oven
must be connected to a single phase 230-240 Volt,
50Hz alternating current supply.
If you do not make the proper electrical connections
you might damage the oven or injure yourself. Neither
SHARP nor the supplier will be liable if this happens.
green and yellow stripes =
EARTH
blue
=
NEUTRAL
brown
=
LIVE
• The green and yellow wire to the plug terminal
marked E
or or
coloured green
or
coloured
green and yellow.
• The blue wire to the plug terminal marked N
or
coloured black
or
coloured blue.
• The brown wire to the plug terminal marked L
or
coloured red
or
coloured brown.
IF YOU HAVE ANY DOUBTS ABOUT YOUR
ELECTRICAL SUPPLY ASK A QUALIFIED
ELECTRICIAN.
TO REPLACE THE MAINS PLUG
TROUBLESHOOTING
Содержание R-352M
Страница 2: ......
Страница 55: ......
Страница 56: ...PRINTED IN U K TINS A125URRO SHARP ELECTRONICS U K LTD Manchester U K LoCall 0345 125387 ...