R-290H(S)
23
Sealer film
Backing film
Adhesive tape
10.Now, door panel with sealer film is free.
11.Tear sealer film from door panel.
12.Now, door panel is free.
13.Slide latch head upward and remove it from door frame
with releasing latch spring from door frame and latch
head.
14.Now, latch head and latch spring are free.
15.Remove door screen from door frame.
16.Now, door screen is free.
17.Unfold each six (6) tab of the door decoration upper and
lower by using a pair of needle-nose pliers. And remove
the door decoration upper and lower from the door
frame. Now, the door frame is loose.
RE-INSTALL
1. Insert each six (6) tab of the door decoration upper and
lower into each slit of the door frame and bend the tabs
by using a pair of needle-nose pliers.
2. Re-install door screen to door frame.
3. Re-install latch spring to the head. Re-install latch
spring to the door frame. Re-install latch head to the
door frame.
4. Re-install door panel to door frame by fitting ten (10)
tabs of door frame to ten (10) holes of door panel.
5. Put sealer film on door panel. Refer to "Sealer Film" and
figure C-8, on how to handle the new film.
6. Catch two (2) pins of door panel on two (2) hole of upper
and lower oven hinges.
7. Re-install choke cover to door panel by pushing.
Note: After any service to the door;
(A) Make sure that 1st. latch switch, 2nd. interlock
relay control switch and monitor switch are oper-
ating properly. (Refer to chapter "Test Proce-
dures".).
(B) An approved microwave survey meter should be
used to assure compliance with proper micro-
wave radiation emission limitation standards.
After any service, make sure of the following :
1. Door latch heads smoothly catch latch hook through
latch holes and that latch head goes through center of
latch hole.
2. Deviation of door alignment from horizontal line of
cavity face plate is to be less than 1.0mm.
3. Door is positioned with its face pressed toward cavity
face plate.
4. Check for microwave leakage around door with an
approved microwave survey meter. (Refer to Micro-
wave Measurement Procedure.)
Note:
The door on a microwave oven is designed to act
as an electronic seal preventing the leakage of
microwave energy from oven cavity during cook
cycle. This function does not require that door be
air-tight, moisture (condensation)-tight or light-
tight. Therefore, occasional appearance of mois-
ture, light or sensing of gentle warm air movement
around oven door is not abnormal and do not of
themselves, indicate a leakage of microwave en-
ergy from oven cavity.
Figure C-7. Door Replacement
SEALER FILM
Installation
1. Put the adhesive tape on the backing film of the sealer
film as shown in Fig. C-8.
2. Tear the backing film by pulling the adhesive tape.
3. Put the pasted side of the sealer film on the door panel
Figure C-8. Sealer film
Pin
Pin
Upper Oven Hinge
Lower
Oven
Hinge
Lower Oven
Hinge
Choke Cover
Slit Choke
Door
Panel
Содержание R-290H
Страница 2: ...R 290H S 36 ...
