Sharp R-230F Скачать руководство пользователя страница 18

Страница: 18 / 32

R-230F

1. Precautions for Handling Electronic Components

This unit uses CMOS LSI in the integral part of the
circuits. When handling these parts, the following pre-
cautions should be strictly followed. CMOS LSI have
extremely high impedance at its input and output
terminals. For this reason, it is easily influenced by the
surrounding high voltage power source, static electric-
ity charge in clothes, etc., and sometimes it is not fully
protected by the built-in protection circuit.
In order to protect CMOS LSI.
1) When storing and transporting, thoroughly wrap

them in aluminium foil. Also wrap PW boards con-
taining them in aluminium foil.

2) When soldering, ground the technician as shown in

the figure and use grounded soldering iron and
work table.

2. Servicing of Touch Control Panel

We describe the procedures to permit servicing of the
touch control panel of the microwave oven and the
precautions you must take when doing so.
To perform the servicing, power to the touch control
panel is available either from the power line of the oven
itself or from an external power source.

(1) Servicing the touch control panel with power

supply of the oven :

CAUTION:
THE HIGH VOLTAGE TRANSFORMER OF THE
MICROWAVE OVEN IS STILL LIVE DURING
SERVICING AND PRESENTS A HAZARD .

Therefore, when checking the performance of the
touch control panel, put the outer cabinet on the
oven to avoid touching the high voltage trans-
former, or unplug the primary terminal (connector)
of the high voltage transformer to turn it off; the end
of such connector must be insulated with an insulat-
ing tape. After servicing, be sure to replace the
leads to their original locations.

A. On some models, the power supply cord be-

tween the touch control panel and the oven itself
is so short that the two can’t be separated. For
those models, check and repair all the controls
(sensor-related ones included) of the touch con-
trol panel while keeping it connected to the oven.

B. On some models, the power supply cord be-

tween the touch control panel and the oven
proper is so long enough that they may be
separated from each other.

SERVICING

For those models, therefore, it is possible to
check and repair the controls of the touch control
panel while keeping it apart from the oven proper;
in this case you must short both ends of the door
sensing switch (on PWB) of the touch control
panel with a jumper, which brings about an
operational state that is equivalent to the oven
door being closed. As for the sensor-related
controls of the touch control panel, checking
them is possible if the dummy resistor(s) with
resistance equal to that of the controls are used.

(2) Servicing the touch control panel with power

supply from an external power source:
Disconnect the touch control panel completely from
the oven proper, and short both ends of the door
sensing switch (on PWB) of the touch control panel,
which brings about an operational state that is
equivalent to the oven door being closed. Connect
an external power source to the power input termi-
nal of the touch control panel, then it is possible to
check and repair the controls of the touch control
panel; it is also possible to check the sensor-related
controls of the touch control panel by using the
dummy resistor(s).

3. Servicing Tools

Tools required to service the touch control panel as-
sembly.
1) Soldering iron: 30W

(It is recommended to use a soldering iron with a
grounding terminal.)

2) Oscilloscope: Single beam, frequency range: DC -

10MHz type or more advanced model.

3) Others: Hand tools

4. Other Precautions

1) Before turning on the power source of the control

unit, remove the aluminium foil applied for prevent-
ing static electricity.

2) Connect the connector of the key unit to the control

unit being sure that the lead wires are not twisted.

3) After aluminium foil is removed, be careful that