21
R-2275
R-2285
SERVICE INFORMATION
IMPORTANT:
When replace the magnetron MG1 and/or MG2, the relays RY2 and RY3 on control unit must
bereplaced at the same time.
CAUTION FOR TOUCH CONTROL PANEL REMOVAL
1. Hold the lower end (Position A, Fig. 1) of the touch control panel ass’y firmly while sliding it down and toward you.
CAUTION: DO NOT FORCE THE CONTROL UNIT TO SLIDE DOWN DURING REMOVAL. THIS MAY CAUSE
DAMAGE TO THE CONTROL UNIT BY HITTING A RELAY (RY-3) OR THE TAB TERMINALS LOCATED
AT THE FRONT OF THE OVEN CAVITY.
2. If the Touch Control Panel is hard to remove.
1, Insert a flat head screw driver into space B . (Fig. 1)
2, Rotate the screwdriver clockwise while holding position C of the Touch Control Panel. (Fig. 2)
CAUTION : TO AVOID DAMEGE TO TOUCH CONTROL PANEL, COVER THE TIP OF SCREWDRIVER WITH TAPE.
3, Resolder the Relay(RY-3) prior to reinstalling the Touch Control Panel.
B
A
C
B
Fig. 1
Fig. 2
TOUCH CONTROL PANEL
SCREW DRIVER
