R-216(G)
R-216(IN)
R-216(W)
R - 2 1 6 ( Y )
21
Power Supply Cord
Oven Cavity
Back Plate
Screw
Green/Yelow
Wire
Brown Wire
Fuse
Blue Wire
Noise Filter
Power Supply
Cord
Oven Cavity
Back Plate
Square
Hole
Moulding
Cord Stopper
Gap
Rotor
Bracket
Stator
Groove joint pliers
Coil
Shaft
Axis
Stator
Rotor
These are the positions
that should be pinched
with pliers.
Shaft
Table
Center of
bracket
Side View
Rear View
2.
Install the fan blade to the fan motor shaft according
to the following procedure.
3.
Hold the center of the bracket which supports the
shaft of the fan motor on the flat table.
4.
Apply the screw lock tight into the hole (for shaft) of
the fan blade.
5.
Install the fan blade to the shaft of fan motor by
pushing the fan blade with a small, light weight, ball
peen hammer or rubber mallet.
CAUTION:
• Do not hit the fan blade strongly when installed
because the bracket may be transformed.
• Make sure that the fan blade rotates smooth
after installed.
• Make sure that the axis of the shaft is not
slanted.
Removal
1. CARRY OUT 3D CHECKS.
2. Remove the single (1) screw holding the green/yellow
wire to the oven cavity.
3. Disconnect the leads of the power supply cord from the
noise filter, referring to the Figure C-4 (a).
4. Release the moulding cord stopper of the power supply
cord from the square hole of the oven cavity back plate,
referring to the Figure C-4 (b).
5. Now, the power supply cord is free.
POWER SUPPLY CORD REPLACEMENT
Re-install
1. Insert the moulding cord stopper of power supply cord
into the square hole of the rear cabinet, referring to the
Figure C-4 (b).
2. Install the earth wire lead of power supply cord and the
earth angle to the oven cavity with one (1) screw and
tight the screw.
3. Connect the brown and blue wire leads of power supply
cord to the noise filter correctly, referring to the Pictorial
Diagram.
Figure C-4 (a). Power Supply Cord Replacement
Figure C-4 (b) Power Supply Cord Replacement
1. CARRY OUT 3D CHECKS.
2. Disconnect the leads from the control unit.
3. Remove the one (1) screw holding the chassis support
to the front plate of the oven cavity.
CONTROL PANEL ASSEMBLY REMOVAL
4. Remove the chassis support from the oven.
5. Lift up the control panel and release it from the oven
cavity.
6. Now, the control panel assembly is free.
6.
Install the fan motor assembly to the oven cavity by
fitting the tabs of the fan duct into the holes of the oven
cavity and the waveguide flange.
7.
Re-install the light mounting plate to the oven cavity
with the one (1) screw.
8.
Insert the end of the chassis support into the slit of the
oven cavity rear cabinet.
9.
Re-install the chassis support to the oven cavity front
plate with the one (1) screw.
10. Install the filament lead and the H.V. wire into the hole
of the fan duct .
11. Re-install the wire leads (to the oven lamp) to the hole
of the fan duct.
12. Connect the wire leads to the fan motor, referring to
the pictorial diagram.
