5
R-209HK
R-209HW
Electrical Requirements
The electrical requirements are a 115 -120 volt 60 Hz, AC only, 15 or 20 amp. fused electrical supply. It is recommended
that a separate circuit serving only this appliance be provided. When installing this appliance, observe all applicable codes
and ordinances.
A short power-supply cord is provided to reduce risks of becoming entangled
in or tripping over a longer cord.
Where a two-pronged wall-receptacle is encountered, it is the personal
responsibility and obligation of the customer to contact a qualified electrician
and have it replaced with a properly grounded three-pronged wall receptacle
or have a grounding adapter properly grounded and polarized. If the extension
cord must be used, it should be a 3-wire, 15 amp. or higher rated cord. Do not
drape over a countertop or table where it can be pulled on by children or tripped
over accidentally.
CAUTION: DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE ROUND GROUNDING PRONG FROM
THIS PLUG.
OVEN DIAGRAM
1 Door open button
Push to open door.
2 Oven door with see-through window
3 Safety door latches
The oven will not operate unless the door is
securely closed.
4 Door hinges
5 Door seals and sealing surfaces
6 Turntable motor shaft
7 Removable turntable support
Carefully place the turntable support in the center
of the oven floor.
8 Removable turntable
Place the turntable securely on the turntable
support. The turntable will rotate clockwise or
counterclockwise. Only remove for cleaning.
9 Ventilation openings (Rear)
10 Oven light
It will light when oven is operating.
11 Waveguide cover: DO NOT REMOVE.
12 Auto-Touch control panel
13 Time display: 99 minutes, 99 seconds
NOTE:
Some one-touch cooking features such as
"MINUTE PLUS" are disabled after three min-
utes when the oven is not in use. These fea-
tures are automatically enabled when the door
is opened and closed or the STOP/ CLEAR pad
is pressed.
3-Pronged
Plug
Grounded
Receptacle Box
Grounding Pin
3-Pronged Receptacle
TOUCH CONTROL PANEL
8
7
12
13
3
2
4
5
11
1
9
10
6
