Sharp QW-NS14I49EX-EN, Руководство пользователя

Страница: 16 / 30

EN - 11
Do not fill overfill the detergent
compartment. Otherwise you can see
whitish streaks or bluish layers on glass
and dishes which may cause glass
corrosion. Continued over-use of detergent
may cause machine damage.
Using too little detergent can result in poor
cleaning and you may see whitish streak
sin hard water.
See the detergent manufacturer’s
instructions for further information.
4.9. Filling with D etergent
Push the latch to open the dispenser and
pour in the detergent.
Close the lid and press it until it locks in
place. The dispenser should be refilled just
before the start of each program. If the
dishes are heavily soiled, place additional
detergent in the pre-wash detergent
chamber.
DETERGENT
4.10. Using C ombined D etergents
These products should be used according
to the manufacturer’s instructions.
Never put combined detergents into the
interior section or the cutlery basket.
Combined detergents contain not only
the detergent but also rinse-aid, salt
replacement substances and additional
components depending on the combination.
We recommend you do not use combined
detergents in short program .
Please use powder detergents in such
program .
If you encounter problems when using
combined detergents, please contact the
detergent manufacturer.
When you stop using combined detergents,
make sure that water hardness and rinse
aid settings are set to the correct level.
4.11. Rinse-Aid Use
Rinse aid helps to dry the dishes without
streaks and stains. Rinse-aid is required for
stain-free utensils and clear glasses. The
rinse aid is automatically released during
the hot rinse phase. If an in-sufficient
amount of rinse aid is used, whitish stains
may be left on the dishes and drying and
washing performance will be impaired.
If too much rinse aid is used you may see
bluish layers on glass and dishes.
4.12. Filling the R inse-aid and S etting
To fill the rinse aid compartment, open
the rinse-aid compartment cap. Fill the
compartment with rinse aid to the MAX
level and then close the cap. Be careful not
to overfill the rinse aid compartment and
wipe up any spills.
In order to change the rinse aid level,
follow the below steps before turning on
the machine:
• Open the door of the machine.
•
•
Turn on the machine, and press the
program button as soon as the
machine is turned on.
Hold down the program button until all
leds blink twice. Rinse aid setting
follows water hardness setting.
• The machine will display the last
setting.
• Change the level by pressing the
program button.
• Switch off the machine to save the
setting.
The factory rinse aid level setting is “4”.
If the dishes are not drying properly or are
spotted, increase the level. If blue stains
form on your dishes, decrease the level.