EN -
19
7.2.
Cancelling a Programme
Follow the steps below to cancel a
programme while in operation.
7.3.
Switching the Machine Off
NOTE:
Do not open the door before the
programme is complete.
NOTE:
If the door of the machine is
opened or the power is cut off while a
programme is in operation, the programme
will continue when the door is closed or the
power returns.
NOTE:
If the power is cut or the
machine door is opened during the drying
process, the programme will terminate.
Your machine will now be ready for a new
programme selection.
Buzzer Sound Control
To change the buzzer sound level, follow
the below steps:
1. Open the door and press Programme (2)
and Half Load (3) buttons simultaneously
for 3 seconds.
2. When sound setting is recognized,
buzzer gives a long sound and machine will
display last set level, from “S0” to “S3”.
3. To decrease sound level press
Programme (2) button. To increase sound
level, press Half Load (3) button.
4. When voice level is changed,
corresponding leds shown below table
illuminate.
Voice
Levels
Leds
1/2
3h
6h
9h
S0
X
S1
X
X
S2
X
X
X
S3
X
X
X
X
5. To save the selected sound level, turn off
the machine.
’’S0’’ level means all voices are off. Factory
setting is “S3.
Save Power Mode
To activate or deactivate save power mode,
follow the below steps:
1. Open the door and press Half Load (3)
and Delay (4) buttons simultaneously for 3
seconds.
2. After 3 seconds, the machine will display
last setting.
3. When Save Power Mode is activated,
P1, P2, 1/2 leds illuminate. On this mode,
interior lights will turn off 4 minutes after the
door is opened, and the machine will turn
off after 15 minutes of no activity in order to
save energy.
4. When Save Power Mode is deactivated
P1, P2 leds illuminate. If Save Power Mode
is deactive, interior lights will be on as long
as the door is open, and the machine will
always be on unless it is turned off by user.
When the door of your machine is
opened, the light corresponding
to the most recently selected
programme will illuminate.
Press and hold the Programme Selection
button for 3 seconds. The End Of
Programme Indicator will flash and the
programme light will switch off.
The water discharge process will start
after the door of the machine is closed
and will continue for 30 seconds.
A
buzzer will sound 5 times when a
programme is cancelled and the End Of
Programme Indicator will illuminate.
The End Of Programme Indicator will illuminate
when a programme is complete. A signal will also
sound 5 times. You can then switch your machine off
using the Power On/Off button.
Disconnect the plug and turn off the
water tap.
