Sharp PN-V701, Руководство по установке

Страница: 6 / 76

Copyright
©
All rights reserved, SHARP CORPORATION
Confidential
5
When using remote controller When using key on the rear panel
Ref. You can check the PN-
V701’s panel status (color, brightness, damage, or existence or nonexistence of
bright point/black point, light leakage, floating) in accordance with the following procedure.
Note that you can’t check all the features of PN-V701 with the following procedure.
Operation check before installation
Confirm if each display can operate properly prior to the video wall installation. If a failure is
confirmed after installation, the labor and time detaching are required.
Carry out the operation check before installation.
1. Press the [SIZE] button (over 5 sec.) and “F” is
displayed at the upper left of screen.
2. Press the [ ] [ ] [ ] [ ] buttons.
3. The screen display changes in the following sequence,
each time you press the [ ] button.
Black, Dark Blue, Dark Green, Dark Red,
Blue, Green, Red, White, Gray1, Gray2.
4. Turn off the power after checking the display.
1. Press the “MENU” and “INPUT” keys (over 5 sec.)
and “F” is displayed at the upper left of screen.
2 Press the [ ] [ ] [ ] [ ] buttons.
3. The screen display changes in the following sequence,
each time you press the [ ] button.
Black, Dark Blue, Dark Green, Dark Red,
Blue, Green, Red, White, Gray1, Gray2.
4. Turn off the power after checking the display.
1.1.Procedures of installation
(Please thoroughly observe these recommendations) 3
A protective film is attached on the display. Remove it before confirming
operation. After the check, it is recommended to reattach the film
until just before the completion of installation to protect the display.
Corner protective
materials
Tape
Protective
film