Sharp Plasmacluster AE-A09DJ, Руководство по эксплуатации

Страница: 8 / 20

CAUTION
• Do not allow the signal receiver window to receive strong direct sunlight, since it can
adversely affect its operation. If the signal receiver window is exposed to direct sunlight,
close a curtain to block the light.
• Using a fluorescent lamp with a quick starter in the same room may interfere with
transmission of the signal.
• The unit can be affected by signals transmitted from the remote control of a television,
VCR or other equipment used in the same room.
• Do not leave the remote control in direct sunlight or near a heater. Also, protect the unit
and remote control from moisture and shock which can discolour or damage them.
1
Remove the battery cover at the back of
the remote control.
2
Insert batteries in the compartment, mak-
ing sure the
±
and
—
polarities are
correctly aligned.
• Lines will be indicated on the display
when batteries are properly installed.
3
Replace the battery cover.
USING THE REMOTE CONTROL
6
NOTES:
• The battery life is approximately one year in normal use.
• When you replace the batteries, always change both batteries, and make sure
they are the same type.
• If the remote control does not operate properly after replacing the batteries, take
out the batteries and reinstall them again after 30 seconds.
• If you will not be using the unit for a long time, remove the batteries from the
remote control.
Point the remote control towards the
unit’s signal receiver window and
press the desired button. The unit
generates a beep when it receives the
signal.
• Make sure there is no curtain or other
object between the remote control and
the unit.
• The operation range of the remote control
is up to 7 metres.
LOADING BATTERIES
Use two size-AAA (R03) batteries.
HOW TO USE THE REMOTE CONTROL
Battery cover