Projector Driver Application Note
Sharp PG-M20x
Revision A
DR-SHP20 – 9/17/03
SP Controls reserves the right to modify specifications without notice at any time.
This document describes the
SmartPanel
Projector Driver for the
Sharp PG-M20X
projector. For more
information on configuring and using the Panel see the
SmartPanel Configuration and Installation
Manual.
I. PROJECTOR CONTROL
A. Volume and Power Control
Volume control on the Sharp is
relative
.
B. Input Selection Mapping
The following table specifies the factory-preset input mapping for this Driver. The
Configuration Utility
can be used to customize these settings your installation.
Selection 1:
DVI
Selection 2:
S-VIDEO
Selection 3:
VIDEO
Selection 4:
VIDEO
Input choices available for the Sharp with this
Driver are DVI, S-VIDEO, and VIDEO
C. Hidden Function Mapping
The following table specifies the factory preset hidden function mapping for this Driver. The
Configuration Utility
can be used to customize these settings your installation.
Selection 1:
ENTER
Selection 2:
UNDO
Selection 3:
ADJUST LEFT
Selection 4:
ADJUST RIGHT
Off:
MENU
Volume Up:
ADJUST UP
Volume Down:
ADJUST DOWN
Hidden functions names are based on the Sharp
remote and controls on top of the projector.
Adjust
controls navigate through onscreen menus. Hidden
functions are accessed by pressing the indicated key while the holding the
On
key down.
The hidden functions available for the Sharp with this Driver are as follows:
MENU
ADJUST LEFT
ADJUST RIGHT
ADJUST UP
ADJUST DOWN
ENTER
E
ENLARGE –
FREEZE
AV MUTE
UNDO
Projector
Ready
Warm-up
OFF
ON
Volume
DVI
S-VDEO
VIDEO
VIDEO
Projector
Ready
Warm-up
OFF
ON
Volume
ADJUST
UP
ADJUST
DOWN
MENU
ENTER
UNDO
ADJUST
LEFT
ADJUST
RIGHT
